User`s guide

23(31)
Datum/Date
Rev
Dokumentnr/Documentnr
Uppgjord/Prepared
Dokansv/Godkänd - Doc respons/Approved Kontr/Checked
Tillhör/Referens-File/Reference
99-07-15 C
265/155 34-ASB 150 02 Uen
FACILITY DESCRIPTION
Faktaansvarig - Subject responsible
Single Assignment
When only single numbers can be added, input this number as first Extension Number and then press
twice <Enter>. Of course any free circuit can be selected by the System Manager.
Delete an Extension Number
Menu path: System Manager - Administrate - Delete - Extension number
This command deletes the definition of a Portable from the IC-CU_ data base. So, the Extension
Number and the associated Temporary Portable User Idetity (TPUI) / Portable Technical Number (PTN)
are deleted. Also the relation with a certain LTC or DTU channel is cleared. After deleting an Extension
Number the same Extension Number can be re-used for another Portable.
This command may be used when a Portable Telephone is lost. A Portable Telephone with a deleted
Extension Number can not place calls any more.
The deleted TPUI / PTN will not be assigned to another Extension Number (Portable) until the cycle is
completed (see Add Extension). This is to provide protection against misuse.
Block deletions
A range of Extension Numbers can be deleted by specifying the first and last Extension Number.
If a range of Portables must be deleted the Extension Number of the first and the last Portable must be
specified.
Single Deletion
When one Portable has to be deleted only the first Extension Number has to be filled in.
List Extension Numbers
Menu path: System Manager - Administrate - List - Extension number
This command lists for each Portable Telephone, defined in the IC-CU_ data base, the Temporary
Portable User Idetity (TPUI) / Portable Technical Number (PTN) and the Line connection.
The Portables are sorted by Extension Number.
Ringing Cadences
Menu path: System Manager - Administrate - Ringing
This command is also invoked by the initialization procedure.
This command specifies three different cadences which are to be recognised by the IC system. The
specified cadences are also used as defaults when programming Portables. If Portable Telephones
must ring with different cadences, use the Portable Ringing command.
The IC system supports three ringing types, referred to as Internal Call, External Call and Call-back.
The cadences are defined by means of three screens. Each ringing type has its own
screen. A ringing type is identified by the time the ringing is active (time = ON) and the time the ringing
is not active (time = OFF).
The IC system uses all the necessary fields that will enable it to recognise the ringing type. Additional