User`s guide

26(31)
Datum/Date
Rev
Dokumentnr/Documentnr
Uppgjord/Prepared
Dokansv/Godkänd - Doc respons/Approved Kontr/Checked
Tillhör/Referens-File/Reference
99-07-15 C
265/155 34-ASB 150 02 Uen
FACILITY DESCRIPTION
Faktaansvarig - Subject responsible
Clear Service Table
Menu path: System Manager - Control - Clear service
This command clears the Service Table. The logging of error messages in this table is stopped when it
is full. To allow the logging of new error messages after corrective actions the Clear Service Table
command must be selected.
Printing of System Error Messages
Menu path: Distributor - Diagnostics/test - Setting - Error messages - Print yes/no
Menu path: System Manager - Control - Print yes/no
This command enables or disables the system printer that is connected to the IC-CU_. If a hard copy of
the messages in the Info Table, Fault Table and Service Table is required by the support specialist, the
option Yes on the print screen must be selected. The selection that is made is stored in EEPROM.
Factory setting: N(o).
Reset Alarm
Menu path: System Manager - Control - Reset - Alarm
Reset Board
Menu path: System Manager - Control - Reset - Board
This command resets an IC-LU board.
Reset Base Station
Menu path: System Manager - Control - Reset - Base Station
This command resets a Base Station and loads the delay value from the IC-CU_ database into the Base
Station. This command must be carried out after downloading new software to a Base Station by means
of the Download One Base command.
Parameters (Recall button)
Menu path: System Manager - Parameters
This command is not applicable for the Integrated Cordless System !