User`s guide

18(20)
Datum/Date Rev
Dokumentnr/DocumentnrUppgjord/Prepared
Dokansv/Godkänd - Doc respons/Approved Kontr/Checked Tillhör/Referens-File/Reference
98-01-31 B
321/155 34-ASB 150 02 Uen
FACILITY DESCRIPTION
Faktaansvarig - Subject responsible
Extension Parameters
0151
Tenant group
This command states the Tenant Group the extension
belongs to.
xxxx Enter the directory number of the extension.
yy Enter the Tenant Group.
0152
Override LCR?
This command states whether or not the extension
may set up calls without Least Cost Routing inde-
pendent if the trunk requests Least Cost Routing or
not.
xxxx Enter the directory number of the extension.
yyy Enter YES to allow the extension to override
Least Cost Routing. Otherwise enter NO.
0153
Direct carrier access?
By means of this command you may authorise an
extension to choose a carrier directly. The selection of
a carrier is done by dialling the Internal Access Code
and the Carrier Access Code.
If an extension has the COS for Direct Carrier Access
LCR, the low-price route is not selected by Least Cost
Routing. However, Least Cost Routing will modify the
dialled directory number according to the requirements
of the carrier.
xxxx Enter the directory number of the extension.
yyy Enter YES to allow the extension to select
a carrier. Otherwise enter NO.
0154
Alternative routing
This command determines the selection of alternative
routes by means of Least Cost Routing.
xxxx Enter the directory number of the extension.
y Enter a Value according to the table below.
Value Alternative choices for LCR
0 Not allowed to use an alternative choice
1 Allowed to use the second routing choice
2 Allowed to use all alternative routing choices
System Data
2024
Initiate public Dialtone at LCR
This command is used to state whether the public
dialtone has to be sent to the caller, after dialling a
directory number of a LCR-controlled trunk.
The parameter programmed by this command is
relevant only if command 2034 is set to YES.
See also command "1026 LCR analysis required".
2034
Dial tone at LCR
This command determines whether the extension shall
receive a proceed-to-select signal after dialling the
16 Aug 17:35 +15˚
TENANT GROUP C 0151 xxxx yy
backward forward c/i return
16 Aug 17:35 +15˚
OVERRIDE LCR ? C 0152 xxxx yyy
backward forward c/i return
16 Aug 17:35 +15˚
Direct carrier acc? C 0153 xxxx yyy
backward forward c/i return
16 Aug 17:35 +15˚
ALT ROUTING C 0154 xxxx y
backward forward c/i return