User`s guide

4(11)
Datum/Date Rev
Dokumentnr/DocumentnrUppgjord/Prepared
Dokansv/Godkänd - Doc respons/Approved Kontr/Checked Tillhör/Referens-File/Reference
97-10-31 B
341/155 34-ASB 150 02 Uen
FACILITY DESCRIPTION
Faktaansvarig - Subject responsible
Serial messages
After a message has been sent, it is possible to send
the same message to other addresses.
The display shows:
Press the menu key yes and the following image will
be displayed:
Enter the directory number for the next extension and
press send.
The procedure can be repeated an unlimited number
of times.
After the last address has been registered press no to
disconnect.
Unless the menu key no or Clear is pressed within
approximately 30 seconds, the message function will
be disconnected automatically and the display will
show idle state information.
To control sent messages
The messages that have been sent can be controlled
to ascertain whether they have been read/listened to,
erased or not erased.
To control one's own sent messages
Extensions can normally only control their own
messages.
From the entry image press check.
It is programmable if there is a password
(=authorisation code) check or not. If it is, the display
shows:
After that the display shows:
Enter the receiver number and press check.
The display shows:
Select the message type by pressing a menu key
corresponding to the message type to check.
Press return to revert to the previous image.
The display shows e.g. if voice has been selected:
10 Jul 14:40 +15˚
MESSAGE IS SENT. SEND TO ANOTHER
yes no
10 Jul 14:40 +15˚
FROM NUMBER: 200 TO NUMBER: _
send chnge-no chnge-no
10 Jul 14:40 +15˚
SELECT FUNCTION
send check
10 Jul 14:40 +15˚
ENTER PASSWORD: _
10 Jul 14:40 +15˚
OWN MESSAGES SENT TO: _
return check chng-no.
10 Jul 14:40 +15˚
SELECT MESSAGE TYPE
return call-back voice free-text