User`s guide

6(8)
Datum/Date Rev
Dokumentnr/DocumentnrUppgjord/Prepared
Dokansv/Godkänd - Doc respons/Approved Kontr/Checked Tillhör/Referens-File/Reference
99-02-17 A
363/155 34-ASB 150 02 Uen
FACILITY DESCRIPTION
Faktaansvarig - Subject responsible
In order to use the features listed above, the internal 4
digit numbering plan has to be used. This situation
might confuse some users, because they have
different directory numbers for internal and CN call
handling.
The total number length of the LOC and the virtual
directory number within the Corporate Network must
not exceed 8 digits.
Programming
The following commands are only accessible via
RASC:
Composition of virtual numbers (calling/connected
number ) presented to the CN network for outgoing
calls
2073
Removed digits for composing A or B number
This command is used in conjuntion with the command
2074 to compose a virtual directory number for the CN
number presentation, especially used for CNs where a
local directory number plan of more than 4 digits is
required.
Composition principle: removing of digits from the
internal directory number and prefixing the edited
digits with the Local private code.
The command 2073 defines the amount of leading
digits, which are removed from the internal directory
number
Values: 0-3 digits
Default: 0
2074
Local private code for composing A or B number
This command is used in conjuntion with the command
2073 to compose a virtual directory number for the CN
number presentation, especially used for CNs where a
local directory number plan of more than 4 digits is
required.
Composition principle: removing of digits from the
internal directory number and prefixing the edited
digits with the Local private code.
This command defines the Local Private Code (LPC),
which is used to prefix the edited directory number .
Values: 1-9999
Default: --
Conversion of the virtual numbers received from
CN to the internal directory number plan.
5413
Create abbreviated number series
This command is normaly used to create a common
abbreviated number series, in this specific case the
command will be used to create a single number,
which must be equal to the Local Private Code.
2501
Translated number
Each common abbreviated number is programmed in
an abbreviated number table and has an individual
assigned number to it.
This command is normaly used to define the external
numbers behind the common abbreviated numbers.
For the virtual number conversion this command is
used to define the digits which were removed by
command 2073 (see previous examples ).
2502 - 2505
Categorisation
For each abbreviated number it can be stated for
which abbreviated number category (0 - 3) it shall be
available.