User`s guide

7(14)
Datum/Date Rev
Dokumentnr/DocumentnrUppgjord/Prepared
Dokansv/Godkänd - Doc respons/Approved Kontr/Checked Tillhör/Referens-File/Reference
99-07-15 F
361/155 34-ASB 150 02 Uen
FACILITY DESCRIPTION
Faktaansvarig - Subject responsible
1015
Number of predigits
This command is used to assign routes and their
members a number which may be used for number
analysis. This parameter will be used primarily by TCD
and LCR.
The number given should contain 1 - 4 digits.
See also TRUNK CALL DISCRIMINATION (TCD),
document 487/155 34-ASB 150 02 Uen.
Categorisation
1001 - 1008
Categorisation
These commands state which facility the trunk belongs
to. The facility category controls the number of facilities
to which the trunk has access to.
Trunks (and extensions) can be divided into 16
different facility categories (Valid data 0-15).
For each category and each facility it is possible to
control whether or not the access to the facility shall be
permitted.
1019
Night service
The command states the night-switching group to
which the trunk belongs.
Valid data: 1 - 8
Night-switching of the PBX means that incoming calls
to each individual trunk are routed to a common
answering position. Night-switching of a trunk group
means that incoming calls on trunks included in the
group will be routed to a common answering position.
Outgoing traffic
1201
Line signalling
The command is used to select the line signal table.
The selection is based on the type of the interworking
exchange connected.
The initial valid data of the used line signal table
depends on the type of the BTU and the market
version.
1013
Dial tone to extension
The command is used to determine whether or not a
dial tone shall be sent to callers (A-party) in case of
outgoing calls.
1014
Result tone to parent exchange
The command is used to determine whether a result
tone shall be sent to the parent exchange. This applies
both to incoming and outgoing calls.
1302
Outgoing digit transmission
The command states how the digits are sent by the
interworking exchange.
The initial valid data depends on the type of the BTU .
Valid data: 0 - 5
0 = Decadic impulsing
1 = DTMF
2 = MFC
3 = No sending of digits
4 = MFE1 ( 2/5 )
5 = MFE2 ( 2/6 )