User`s guide

8(14)
Datum/Date Rev
Dokumentnr/DocumentnrUppgjord/Prepared
Dokansv/Godkänd - Doc respons/Approved Kontr/Checked Tillhör/Referens-File/Reference
99-07-15 F
361/155 34-ASB 150 02 Uen
FACILITY DESCRIPTION
Faktaansvarig - Subject responsible
The following default valid datas are trunk board
dependent:
Valid data : BTU-A =0
BTU-C =0
BTU-E =0
BTU-D =2
1303
Impulse Type
The command is used at impulsing to determine the
dialed digit's relation to the number of pulses.
The number of impulses 1 2 3 4 5 6 7 8 9 10
Valid data: 0-3
0 = digit 1 2 3 4 5 6 7 8 9 0
1 = digit 0 1 2 3 4 5 6 7 8 9
2 = digit 9 8 7 6 5 4 3 2 1 0
3 = digit 0 9 8 7 6 5 4 3 2 1
1304
Impulse frequency
The command states which impulse frequency is to be
used at decadic impulsing.
Valid data : Yes / No
Yes = 10Hz
No= 16 Hz
1305
Impulse ratio
The command is used to determine which make/break
relation (stated in percent) that is to be used at decadic
impulsing.
Valid data: Yes / No
Yes = 40/60
No = 33/67
1306
Inter digit pause
The command is used to determine the pause
between the digits valid for decadic impulsing.
Valid data: 00 - 15
00 = 300ms 08 = 700ms
01 = 350ms 09 = 750ms
02 = 400ms 10 = 800ms
03 = 450ms 11 = 850ms
04 = 500ms 12 = 900ms
05 = 550ms 13 =950ms
06 = 600ms 14 = 1000ms
07 = 650ms 15 = 1050ms
1307
Proceed-to-send signal from exchange
The command is used to state whether the exchange
shall wait for a proceed-to-send signal (PTS signal)
from the parent exchange. See command 1404 for
wrong proceed-to-send signal if the exchange does
not send any signal.
(Command 1308 states whether the proceed-to-send
signal is the dial tone. See also command 1013, which
states whether dial tone shall be sent to the
extension.)
1308
Dial tone from parent exchange
The command states whether the proceed-to-send
signal from the parent exchange is the dial tone.
(Command 1307 states whether a proceed-to-send
signal is sent by the parent exchange. See also
command 1013 which states whether a dial tone shall
be sent to the extension.)