User`s guide

9(14)
Datum/Date Rev
Dokumentnr/DocumentnrUppgjord/Prepared
Dokansv/Godkänd - Doc respons/Approved Kontr/Checked Tillhör/Referens-File/Reference
99-07-15 F
361/155 34-ASB 150 02 Uen
FACILITY DESCRIPTION
Faktaansvarig - Subject responsible
1404
Waiting time before digit transmission
The command is used to determine the shortest time
required by the parent exchange to receive digits for
outgoing calls from ASB 150 02. The function is used
when the parent exchange does not send any
proceed-to-send signal as acknowledgement.
Valid data: 0 - 255 seconds
0 = No waiting time before
digit transmission
1705
Clearing backwards type
The command is used to state whether clear
backwards shall take place with a break in the loop
(Y=Yes). For the alternative (N=No) clear backwards
is achieved with pol. reversal back to idle polarity.
1710
Outgoing traffic, Seizure acknowledge
The command is used to state whether the line signal
"seizure acknowledge" shall be received (exists) at an
outgoing call.
NOTE: Ascertain that the signal is included in the
selected line signal scheme.
1712
Outgoing traffic, EOS-signal
The command is used for outgoing traffic to state
whether the EOS-signal shall be received after the
interworking exchange has received the full number.
NOTE: Ascertain that the signal is included in the
selected signal diagram.
1717
Outgoing traffic: Answering signal
The command is used to state whether the line signal
"answer" shall be received (exists) at outgoing calls.
NOTE: Ascertain that the signal is included in the
selected line signal scheme.
2009
Tone time per digit for DTMF-signalling
Determines the tone time per digit in milliseconds.
Valid data: 0-255
NOTE: Tone time = 0 gives continuous tone
transmission (of first keyed digit).
Intended for use when measuring the
DTMF-signal.
2010
Interdigital pause for DTMF-signalling
Determines the pause between digits for DTMF-
signalling.
1401 - 1423
Monitoring times
This command group is used to determine the
supervision times for the traffic block.