User`s guide

10(14)
Datum/Date Rev
Dokumentnr/DocumentnrUppgjord/Prepared
Dokansv/Godkänd - Doc respons/Approved Kontr/Checked Tillhör/Referens-File/Reference
99-07-15 F
361/155 34-ASB 150 02 Uen
FACILITY DESCRIPTION
Faktaansvarig - Subject responsible
Incoming traffic
1103 - 1104
Answering positions
See also ANSWER POSITION(S) FOR TRUNKS,
document 112/155 34-ASB 150 02 Uen.
1021
Receive digits for incoming traffic
The command is used to state that incoming traffic on
the line is associated with digit reception.
Valid data: Yes/No
Ye s
for direct in-dialing lines and automatic
incoming private trunks (tie lines).
No
the call will be signalled to the extension
that has been programmed as individual
answering position.
1023
Type of trunk
The command is used to state to which type of trunk
the BTU is connected.
Valid data: 0-2
0 = Trunk to a public exchange (PE)
1 = Trunk from a public exchange with
direct in-dialing (INDIALING)
2 = Trunk to a private exchange,
tie line (TIE LINE)
1309
Dial tone to superior exchange
The command states whether the PTS-signal for
incoming traffic consists of a dial tone.
1311
Number of received digits before EOS-signal
The command is used to determine the number of
received digits for automatic incoming traffic before
sending the EOS-signal to the superior exchange, e.g.
a predetermined number of digits is always received
before the EOS-signal is sent.
Valid data: 1 - 4 digits.
1706
Incoming traffic, Seizure acknowledge
The command is used to state whether the signal
"seizure acknowledge" shall be sent as reply to
"seizure" at an incoming call.
Valid data: Yes or No
NOTE: Ascertain whether the signal is included
in the selected line signal scheme.
1707
Incoming traffic, PTS-signal
The command is used to state whether the "Proceed-
To-Send" signal (PTS) shall be sent as line signal for
an incoming call.
Valid data: Yes or No
NOTE: Ascertain whether the signal is included
in the selected line signal scheme.
If "Proceed-To-Send" signal is to be sent as dial tone it
is defined by command 1309.
1709
Incoming traffic, Answering signal
The command is used to state whether the line signal
"answer" shall be sent at an incoming call when the
call is answered in the exchange.
Valid data: Yes or No
NOTE: Ascertain whether the signal is included
in the selected line signal scheme.