User`s guide

54(59)
Datum/Date Rev
Dokumentnr/DocumentnrUppgjord/Prepared
Dokansv/Godkänd - Doc respons/Approved Kontr/Checked Tillhör/Referens-File/Reference
99-07-15 A
365/155 34-ASB 150 02 Uen
FACILITY DESCRIPTION
Faktaansvarig - Subject responsible
1944
Request of UUS service 2
NOTE:This command is only applicable for the
T-interface.
This command states whether UUS (User-to-User
Signalling) service 2 is requested explicitly at this
interface. Explicit request means that the request is
included in the FACILITY (for some markets) IE
(Information Element) in the SETUP message.
Valid data: Yes/No
No
not requested (implicitly)
Ye s
explicitly requested
Default data: Yes
1945
Request of UUS service 3
NOTE:This command is only applicable for the
T-interface.
This command states whether UUS (User-to-User
Signalling) service 3 is requested explicitly on this
interface.Explicit request means that the request is
included in the FACILITY (for some markets) IE
(Information Element) in the SETUP message.
Valid data: Yes/No
No
not requested (implicitly)
Ye s
explicitly requested
Default data: Yes
Proprietary service - Call back
0177
Initiate call back to CN ?
This command defines whether an extension is
allowed to request a call back from the CN.
Valid data: Yes/No
Default data: No
9001
Call setup version at network Call back
This command states which version of call setup is
used at the execution of network Call back towards an
ISDN network.
Version 1: A transmission path between originating
and terminating PBX is established and
the called party is reserved before the
initiating party is called. When the
initiating party answers the call, the
party in the terminating PBX is called.
Version 2: The initiating party is called and when
the party answers, a new call is set up
to the called party.
For version 1 UUS services 1 and 2 have to be
supported by the connected ISDN network, for version
2 only UUS service 1 is needed.
All nodes in a private or public network must have the
same call setup version for using CN Call back.
If the the private network is an MD110 BC10 network
(see command 2072 ), Version 1 is not available and
Version 2 has to be used.
Valid data: Version 1
Version 2
Default data: Version 1
Note: All proprietary systems in the CN network, have
to be configured with the same call set up version.