User`s guide

55(59)
Datum/Date Rev
Dokumentnr/DocumentnrUppgjord/Prepared
Dokansv/Godkänd - Doc respons/Approved Kontr/Checked Tillhör/Referens-File/Reference
99-07-15 A
365/155 34-ASB 150 02 Uen
FACILITY DESCRIPTION
Faktaansvarig - Subject responsible
9002
Active time for a "CB on busy" mission in the init.
PBX (T1)
This command defines the time of a network Call back
on busy mission in the initiating PBX.
If this timer expires, the PBX initiates the cancellation
of the Call back service.
The timer can be programmed in steps of 5 minutes.
The same value must be programmed in all PBXs in
the CN.
Valid data: 0005 - 0855 (hhmm).
Default data: 120 min.
NOTE:The programmed value must be reduced by
5 minutes compared tothe programmed value
stated in command 9004 !
9003
Active time for a "CB on free" mission in the init.
PBX (T1)
This command defines the time of a network Call back
on free mission in the initiating PBX.
If this timer expires the PBX initiates the cancellation of
the Call back service.
The timer can be programmed in steps of 5 minutes.
The same value must be programmed in all PBXs in
the CN.
Valid data: 0005 - 0855 (hhmm)
Default data: 120 min.
NOTE:The programmed value must be reduced by
5 minutes compared tothe programmed value
stated in command 9005 !
9004
Active time for a "CB on busy" mission in the
superv. PBX (T2)
This command defines the time of a network Call back
on busy mission in the supervised PBX.
If this timer expires, the PBX initiates the cancellation
of the Call back service.
The timer can be programmed in steps of 5 minutes.
The same value must be programmed in all CN PBXs
Valid data: 0005 - 0855 (hhmm)
Default data: 125 min.
NOTE:The programmed value must be at least
5 minutes higher than the programmed value
stated in command 9002 !
9005
Active time for a “Call back on free” mission in the
supervised PBX (T1)
This command defines the time of a network Call back
on free mission in the supervised PBX.
If this timer expires, the PBX initiates the cancellation
of the Call back service.
The timer can be programmed in steps of 5 minutes.
The same value must be programmed in all PBXs in
the CN.
Valid data: 0005 - 0855 (hhmm)
Default data: 125 min.
NOTE:The programmed value must be at least
5 minutes higher than the programmed value
stated in command 9003 !
9006
Maximal ringing time at the initiating extension for
Call back calls
This command specifies the time during which the
initiating extension is ringing at network Call back calls.
If this timer expires the PBX initiates the cancellation of
the Call back service.
The same value must be programmed in all PBXs in
the CN.
Valid data: 1 - 255 sec.
Default data: 8 sec.