User`s guide

9(38)
Datum/Date Rev
Dokumentnr/DocumentnrUppgjord/Prepared
Dokansv/Godkänd - Doc respons/Approved Kontr/Checked Tillhör/Referens-File/Reference
99-07-15 F
380/155 34-ASB 150 02 Uen
FACILITY DESCRIPTION
Faktaansvarig - Subject responsible
Outgoing calls to a busy extension
Busy extension
If the desired extension is busy, the operator can
initiate a call back:
A ringing signal and the flashing loop key lamp indicate
that the desired extension is free.
The Operator has to answer within thirty seconds,
otherwise the call will be released automatically.
*) This step is not necessary when calling a CN
destination.
An operator can only have one active ’call back’
supervision at a time.
Note:
If an operator calls a busy extension in the own
system, then called extension will not be informed that
a further call is waiting.
If an operator calls a busy CN extension, the call will
always be camped on, and the called destination will
receive a call waiting tone
Transfering to a busy extension
An incoming caller would like to be transferred to a
specific extension, but the called extension is busy:
Option 1: Transfer the call directly to the busy extension
After transfering ther call the operator is no longer
involved in the call.
*) This function is not available for a centralised
operator in a corporate network when calling a
corporate network number.
Option 2: Transfer the call when the busy extension
becomes free again.
This option is normally only used when the operator
wants to announce the call before transfering.
Notify
Press
Loop 1
Press any free loop key
The key lamp shows steady light.
Loop 1
Press again
Press to call the extension *)
Speech
Press and hold (see display)
info
The conversation partner of the
busy extension is shown
on the display *)
Press to place the call
The call is camped on to the busy
extension, which will receive a
call waiting tone.
Notify
Press
Loop 1
Press any free loop key
The call is now in camped on state,
the busy extension will receive
a call waiting tone.