Operator`s manual

PUBLIC ADDRESS: Press the MENU button
until "PUB ADDR" appears in the display. Press
PTT to transmit in PA mode.
SCAN ADD/DELETE: Press the MENU button
until "SCAN A/D" appears in the display. Use the
GROUP/SEL- button to step through the group
selections for the current system. Use the
GROUP/SEL + button to change the scan state.
An "S" is illuminated to the right of the display if
the group/channel has SCAN enabled.
ALARM ON/OFF: Press the MENU button until
"ALM ON" or "ALM OFF" appears in the display.
Press the GROUP/SEL + or - buttons until the
desired state is selected. (Note: This enables or
disables the external alarm; e.g. horn or lights.)
STATUS: Press the MNU button until "STATUS"
appears in the display. To review or change the
selection,use the GROUP/SEL keys to
view/change the selection of the status message.
When the desired status is displayed, press the PTT
switch to initiate the status transmission.
MESSAGE: Press the MNU button until "MES-
SAGE" appears in the display. To review or
change the selection, use the GROUP/SEL keys
to view/change the selection of the message.
When the desired message is displayed, press the
PTT switch to initiate the message transmission.
SCN Momentary switch. Press the SCN button to en-
able or disable scan operation. The SCN indicator
will light when scan is enabled. Pressing and
holding the SCN button while on a conventional
channel or an EDACS working channel will permit
the user to adjust the squelch setting from the front
panel by using the VOLUME ramp switch to open
and close the squelch.
10