Operator`s manual

unit, all other radios in that group will receive a "System Busy" tone if they
try to access the system.
OPERATING THE RADIO
TURNING THE RADIO ON
1. Push the POWER switch. The display shows the group alpha name
once power up is complete. When powering up, the last selected
Group or Channel should be displayed unless the radio is pro-
grammed for a pre-programmed power up System/ Group. The radio
optionally generates a beep once the power up sequence is complete.
On radios with Multi-site features enabled, the radio automatically
logs onto the system once power up is complete.
2. Set the volume using the VOLUME RAMP button. A short beep
sounds each time the VOLUME button is pressed. The beeps will not
sound if a call is being received.
SELECTING SYSTEM/GROUP/CHANNEL
Use the GROUP/SEL and SYStem controls to select a different Group,
System, or Channel.
Group Selection
1. If the unit is in Menu Mode, press and release the CLR button to
return the radio to normal operation.
2. Press the GROUP/SEL + or - ramp button until the desired Group
name appears in the alphanumeric display. A tone sounds each time
the Group name changes (unless a call is being received).
System Selection
1. If the unit is in Menu Mode, press and release the CLR button to
return the radio to normal operation.
2. Press and release the SYS button to bring up the currently selected
system. Press and release the SYS button again to increment the
System selection.
3. If you want to ramp the system choices up or down, press the
GROUP/SEL + or - ramp button while the system name is displayed.
22