Operator`s manual

1. Make sure the radio is turned ON.

2. Press the MNU button until PUB ADDR appears in the display. Press

the PTT switch to transmit the microphone audio to the external

speaker.

3. When the PA operation is completed, press the CLR button to return

to normal operation.

1. Make sure the radio is turned ON.

2. Press the A1 or A2 button (pre-programmed). When PUB ADDR

appears in the display press the PTT switch to transmit the micro-

phone audio to the external speaker.

3. After the PA operation is completed, press the A1 or A2 button to

return to normal operation.

EDACS TRUNKED OPERATION

PLACING A TRUNKED DISPATCH CALL

To send a message on a trunked system, proceed as follows:

1. Select the System and Group you wish to transmit on.

2. Press and hold down the PTT button.

3. You will hear a short beep (unless the radio is programmed to mute

the beeps) indicating that you have access to the system. When you

hear the beep, you may begin your message. (Note: If you hear two

or more tones or a continuous tone, the system may be busy, your

request has been placed in queue, or your call request has been denied

for some reason. Refer to ALERT TONES for more details.)

4. After you have finished your call, releasing the PTT button ends the

call automatically.

If the group you wish to transmit on is not in the list, a properly

programmed System Model MDX has the capability of operating on a

user selected group ID.

NOTE