Operator`s manual

MANUALLY ENTERING A GROUP ID (System Model Only)

1. Press the A2 button and observe "GID ENTR" in the display

2. Enter the group ID number using the numeric keypad. (Valid range

1-2047).

3. Press the A2 button again and observe "GID nnnn" (where nnnn is

the entered number) in the display. This new group will replace the

first group in the list.

RECEIVING AN EMERGENCY MESSAGE

From The Selected Group

When an emergency is received from a member of your selected group,

"EMERGNCY" flashes on your display.

If an emergency call is made, "E*xxxxxx" (where xxxxxx is the balance

of the group display) will flash in the display until the call is complete.

When an emergency transmission is received from a member of your

selected Group or System; the "E*" portion of the display will flash, the BSY

indicator will come on, and a tone sounds. When this occurs, follow your

standard emergency procedures. The emergency display remains on until the

emergency is cleared.

It is recommended that a null group be programmed into the first

location initially. This will avoid overwriting a desired group from the

list unintentionally.

NOTE

In rare instances, several low pitched, fast "chirps" will be heard before

the Call Originate tone sounds. This is caused by your radio

automatically re-trying to gain access to the system after the first

attempt failed (Auto-Retry). This normally occurs in fringe areas and

in heavily used systems. The Auto-Retry is one of the features utilized

by the radio system to provide reliable communications under adverse

conditions.

NOTE