Operator`s manual

Placing A Telephone Interconnect Call (On Systems Equipped With In-
terconnect Hardware)
1. Make sure the radio is turned ON, and the proper System has been
selected. Press the MENU button until the name SPC CALL appears
in the display. Press the GROUP/SEL + or - buttons until the desired
name appears in the display. The number may be entered manually
on the 12 button keypad of the System Model radio.
2. Press the PTT button momentarily and release for a pre-programmed
number. Press the "*" key for a manually entered number on the
System Model radio.
3. The radio automatically transmits the pre-programmed number
stored in the radio’s memory. The system dials the number and the
ringing tone is heard on the radio. When the landline party answers,
you may speak to them by pressing the PTT button and talk.
4.
To terminate the call, momentarily press the CLR button or hang up
the microphone.
Answering A Telephone Interconnect Call
1. Receiving a telephone interconnect call is much like receiving an
individual call (refer to RECEIVING AN INDIVIDUAL CALL).
When the telephone call is received, the radio displays PHN CALL.
2. To terminate the call, momentarily press the CLR button or hang up
the microphone.
3. If you were out of the vehicle when the call came in, the display will
show "C*" or "*C" or P1 & P2 indicators will flash to indicate that
a call was received. If you select SPC CALL from the menu, the "C*"
or P1, P2 indicator, will go away if the call was a phone call. See
RECEIVING AN INDIVIDUAL CALL for more detail.
Your MDX radio is capable of simplex (one way) conversation only.
The person you are talking to can hear you ONLY when you have the
PTT button pressed. You can hear the person on the telephone ONLY
when the PTT button is released.
If you leave the PTT button released for too long, the system will send
three beeps. When you hear these beeps, you have five seconds to press
the PTT button before the call is automatically terminated.
NOTE
27