Operator`s manual

Adding/Deleting To/From Scan

To add a Group to Scan,

1. Press the MENU button until SCAN A/D is displayed for menu

operation.

2. Press the GROUP/SEL (-) button until the GROUP name is dis-

played.

3. Press the GROUP/SEL (+) button until the desired level is displayed

(NONE or S).

4. Press the CLR button when complete to return to normal operation

or menu operation.

If your radio has one of the auxiliary keys pre-programmed to edit the

SCAN list, the list may be changed by using the GROUP/SEL buttons to

display the GROUP name, and then pressing the auxiliary key until the desired

level is displayed.

Starting Or Stopping Scan

1. Press the SCAN button until either the "SCN" indicator goes off or

on.

RECEIVING A CALL

When a call is received by the radio, the call is decoded. A single alert tone

will sound indicating a group call has been received or a two tone alert will

sound if an individual call has been received. The display will show the system

or area and group when receiving a group call and the system or area and

1. The radio will remember the scan state through a power cycle

unless programmed with a predefined power up state.

2. The radio may be programmed to stop scanning when the micro-

phone is removed from teh hookswitch.

3. When the radio is programmed, a FIXED SCAN list can be

specified. If this is done, the SCAN list cannot be changed.

NOTE