Operator`s manual

call can now be attempted in the new service area. If all available
repeaters are busy when the call is attempted, 1 long beep is heard
and BUSY is displayed. If the call retry option has been enabled
through programming, RETRYING displays instead of the BUSY
message.
6. The Selected area and group is displayed again once the call is
completed.
RECEIVING A TRUNKED DISPATCH CALL
1. You will hear a beep each time you have an incoming call (unless the
radio is programmed to mute the beep). A single beep indicates you
are receiving a group call. Two beeps (high-low) indicate you are
receiving an individual call. You will then hear the voice message.
You can answer the call by pressing the PTT button.
2. When you hear a high pitched beep, someone in your system has tried
to call you, but the call was queued because the system is busy. These
beeps let you know you will receive a call shortly.
SPECIAL CALLS
The Special Call feature within the menu operation allows you to make
calls to individual radios, Telephone Interconnect Calls and/or System All
Calls.
Placing A Telephone Interconnect Call (On Systems Equipped With In-
terconnect Hardware)
1. Make sure the radio is turned ON, and the proper System has been
selected. Press the MENU button until the name SPC CALL appears
in the display. Press the GROUP/SEL + or - buttons until the desired
name appears in the display. The number may be entered manually
on the twelve button keypad of the System Model radio.
In some modes of operation such as an agency call, fleet call, or
individual call, you must answer the caller within several seconds. If
not, two short beeps will sound, the call will be terminated, and normal
system operations will resume.
NOTE
37