Operator`s manual

3. Press PTT and send the message. TX displays when the radio is
transmitting.
CONVENTIONAL MODE OPERATION
1. Select the conventional mode system using +/- ramp button.
2. Determine if the channel is in use before making the call by pressing
CLR to momentarily disable the squelch and monitor the channel for
activity. Also, removing the microphone from the holder disables
Channel Guard which allows monitoring of the channel without
disabling the squelch.
3. Press PTT to send the message.
RECEIVING A CALL
1. Make sure that the radio is turned
ON, and the proper channel is
selected using the GROUP/SEL + or - ramp button and the SYS
button.
2. Press the CLR button to monitor the channel. Noise will be heard if
there is no activity on the channel. This function is also useful for
setting the desired volume level.
3. You will hear the voice message automatically if a valid message is
received by your radio.
SENDING A MESSAGE
1. Make sure the radio is turned ON, and the proper Channel and System
have been selected.
2. Press the CLR button to determine if the channel is in use. Never
transmit a message with your radio while the channel is being used
by someone else. Also observe the BSY indicator (lighted when
channel in use).
3. Press the PTT button and speak into the microphone. The TX indica-
tor will light each time the PTT button is pressed.
4. Release the PTT switch and wait for an answer to your call. Then
complete your message.
40