Operator`s manual

• Off-hook scan not enabled (default):

With off-hook scan not enabled (normal default condition), all scan-

ning will stop when the microphone is placed off-hook. The SCN

indicator will flash to show all scanning has stopped. If a signal is not

being received when the microphone is placed off-hook, the radio will

transmit on the SELECTED channel. If a signal is being received

when the microphone is placed off-hook, the radio can be PC pro-

grammed (using the "scan transmit option") to either stay on the

receive channel or revert to the SELECTED channel. When the

microphone is placed back on-hook, the radio will immediately start

scanning, even if the received channel was still active.

• Off-hook scan enabled:

With off-hook scan enabled, moving the microphone off-hook will

not affect scan operation. The radio will continue scanning. If a signal

is not being received, the radio will transmit on the SELECTED

channel. If a signal is being received, the radio can be PC programmed

(using the "scan transmit channel" option) to either stay on the receive

channel or revert to the SELECTED channel when the mic PTT is

keyed.

• On-hook

When the microphone is on-hook (in the microphone hanger) and the

radio is not receiving a channel, the radio always transmits on the

SELECTED channel.

When the radio is receiving a channel the radio’s personality can be

programmed to transmit either on the received channel or the SE-

LECTED channel. If the radio was programmed for the SELECTED

channel, the display changes to the SELECTED channel when the

transmitter is keyed.

Monitor (CLR) Switch Operation In Scan

The CLR switch does not operate while scanning inactive channels. When

a channel becomes active, the CLR switch operates only during the scan hang

time after the channel activity disappears.

Channel Changes In Scan

Pushing the channel switches (UP or DOWN) while scan is turned on will

change the SELECTED channel assignment. If a signal is being received and