Operator`s manual

the channel switches are pushed, the radio will revert to the new SELECTED
channel assignment. After 2 seconds, if no activity appears on the new
SELECTED channel, scanning will resume. If the SELECTED channel is
changed to a channel not in the scan list, the new channel will be temporarily
added to the scan list until the SELECTED channel is changed again.
• Temporary channel deletions
The SCAN function must be turned off to make any permanent
changes (additions, deletions, re-priorizations) to the scan list. While
in scan, temporary channel deletions may be made to the scan list.
The original scan list will be back in effect by either turning scan off
(by pushing the SCAN switch ) or by turning the radio power off and
back on.
When the radio stops scanning on an active channel, the channel may
be temporarily deleted by pressing the applicable A1 or A2 key
(pre-programmed for SCAN ADD/DELETE) or by going into Menu
mode SCAN A/D and pressing the GROUP/SEL (+) button. The
radio will immediately resume scanning while skipping over the
temporarily deleted channel.
Temporary deletions cannot be made until the radio stops on an active
channel. P1 and P2 channels cannot be temporarily deleted.
45