Installation manual

LBI-38987B CONFIGURATION
16
GETC SOFTWARE INSTALLATION
The GETC software installation procedure involves
installing the latest version of the EPROM containing the
GETC operating software.
NOTE
Download applicable Field Macros into the PC
Programmer TQ-3357 prior to configuring the
GETC software.
SCAT Station GETC
The following procedures provide instructions for
installing the GETC software 349A9607G5 into the SCAT
Station GETC:
caution
h
Observe precautions
for handling
ELECTROSTATIC
SENSITIVE DEVICES
NOTE
Upgrading to Release 5 software is backward
compatible in functionality with 344A3835G2
software. However, GETCs using the
19D904266G1 Logic Board must be upgraded to
the 80C320 microprocessor (U1), and
19A704727P4 Modem (U4 & U19).
The Turbo Board using 344A4414G5 software
must also be upgraded to include a Ferrite Toroid.
Refer to the Upgrading Hardware section for
details.
1. Power down the channel and place the GETC into
the service position. Refer to LBI-38894 if
necessary.
2. If the Turbo Board is not installed, remove RAM
chip U3 and install Turbo Board. Refer to LBI-
38822 for instructions.
3. Ensure Modem chips U4 and U19 are TI AMPS
modems 19A704272P4. TI Amps modems are
required when upgrading to 349A9607G5, replace
if necessary.
4. Ensure microprocessor U1 is the “Speedy”
microprocessor 80C320 (RYT 121 6060/A). This
processor is required when upgrading the software
to 349A9607G5. The processor is available in the
Speedy Upgrade Kit SPK9505. Replace if
necessary. Refer to LBI-38894 for installation
instructions.
5. Ensure Turbo Board harness has Ferrite Toroid
installed. Toroid is included in the SPK9505
Speedy Upgrade Kit. Replace if necessary. Refer
to LBI-38822 for installation instructions.
6. Remove the old EPROM (U2) from the GETC
Logic Board.
7. Install the new EPROM into the XU2 socket, being
sure to properly orient the chip.
8. Remove EEPROM U35, if necessary, from the
Logic Board. The GETC personality will reside in
the Turbo Board and this device is no longer
required.
9. Power up the channel.
10. Place the Turbo processors U1 and U2 in the
program mode by switching Turbo Board switches
S2 and S3 toward the front of the Turbo Board.
11. Download the Turbo Board Software from the disk
provided in the Turbo Media Kit, 344A4414.
Refer the Turbo Board Software Installation
section, SRN1060, SRN1062, and LBI-38822.
12. After downloading the Turbo Board software,
move switches S2 and S3 toward the back of the
Turbo Board and press the GETC Logic Board
Reset button, S4.
13. The two LEDs on the Turbo Board should light.
14. Program the GETC’s personality using the
Personality Programming procedures contained in
this manual and the detailed instructions contained
in TQ-3357 and SRN1060.
15. Verify system performance using the Operational
Checkout procedures.
De-installing The GETC-1e Software
If a problem arises while upgrading or installing the
new software, it may be necessary to de-install the software.
Restoring the site to its original configuration will depend on
the original hardware platform. The two cases are described
below.
If the original equipment configuration was a GETC1e
(GETC with Turbo) platform, then perform the following
steps:
CAUTION
NOTE
NOTE