Installation manual

LBI-38987B CONFIGURATION
20
GETC into the Personality Programming mode.
4. Verify that front panel LEDs L3, L4, and L5 are ON, as
shown in Table 4. This indicates the GETC is ready for
programming.
Table 4 - Indicators in Programming Mode Using J100
LED Indicators L1 L2 L3 L4 L5 L6 L7
Programming Mode
❍❍●●●❍❍
Legend:
❍
= OFF
●
= ON
❉
= FLASHING
5. Review the SCAT Personality section in the manual and
proceed with the Personality programming as described
in TQ-3357 Chapter 4.
6. After saving the personality and downloading it into the
GETC, perform an operational checkout of the GETC.
Programming a Personality Using TQ-3357
Version 4.03 (or later)
When using TQ-3357 Version 4.03 (or later), program
the personality through J104.
1. Connect one end of the serial programming cable (TQ-
3360) to the computer. Connect the other end of the
cable to the GETC Shelf connector J104. See Figure 9.
2. Move Switch S2 on the Turbo Board to the front
placing the GETC into the Personality Programming
mode. See Figure 9.
3. Verify that front panel LEDs L6 and L7 are flashing, as
shown in Table 5. This indicates the GETC is ready for
programming.
Table 5 - Indicators in Programming Mode Using J104
LED Indicators L1 L2 L3 L4 L5 L6 L7
Programming Mode
❍❍❍❍❍
❉❉
Legend:
❍
= OFF
●
= ON
❉
= FLASHING
5. Review the SCAT Personality section in the manual and
proceed with the Personality programming as described
in TQ-3357 Chapter 4.
12345678
S1
12345678
S2
12345678
S3
OPEN OPEN
OPEN
Figure 8 - Programming DIP Switch Settings
S4
S3S2S1
L1 L2 L3 L4 L5 L6 L7
T1 T2
U18R1
1
1
1
1
1
U19
U3
U2
U1
U4
J3
J49
J27
J10
J9 J8 J5
J19
J7
TP107
U1
U2
Software Disk
TQ3357 V4 or later
To
COM Port
Turbo Board GETC Logic Board
J103 J104
J2
J3
Harness
19C337712G1
TQ-3360
TQ-3357
S2
S3
GETC Shelf 19D901868G3
Cable
Figure 9 - System Hook-Up Using J104