Installation manual

CONFIGURATION LBI-38987B
23
6. Read the existing personality from the SCAT Station
GETC to the PC. If the personality does not exist,
retrieve the sample SCAT Personality (shown in Table
6) from the PC. Change the personality parameters as
required.
NOTE
The personality data for SCAT Downlink GETC
must be the same as the Station GETC.
7. After entering the personality parameters, select the
"Program Card" function to program the personality
into the GETC.
8. Verify that the GETC has properly stored the
personality data by selecting the "Read Unit Into File"
function while in the Current Personalities Screen.
9. After completing the programming, save the revised
personality to disk.
10. Reset the DIP switches and press S4 to reset the GETC.
11. Disconnect the TQ-3360 cable and verify GETC
operation.
SCAT Personality
CEC/IMC Personality Configuration
At the System Manager, configure the SCAT groups as
TRACKED to maximize the availability of the SCAT
channel. As a TRACKED group, the SCAT channel only
receives requests from the CEC/IMC for groups that are
logged into the SCAT system. The CEC/IMC bypasses the
SCAT system with other multisite calls making the SCAT
channel available for users within the SCAT system
coverage area. Refer to LBI-38984 for System Manager
programming.
Confirmed Calls
The CEC/IMC may experience excessive delays waiting
for a confirmation response from a SCAT system. To
prevent unnecessary delays, we recommend SCAT systems
be excluded from Confirmed Calls. At the CEC/IMC
Manager, set the Confirmed Call Parameter to "
Y
- Ignore
Site for Call Confirmation." Refer to the EDACS CEC/IMC
Manager (MOM PC) Operation's Manual, LBI-39024,
section 3.2.9.
Wide Area Digital Option
The Wide Area Digital option is activated at the factory
using a unique code for each repeater. This code is stored
with the GETC Personality.
Thus changes to the personality should be made by
reading the existing personality, modifying the data, and
writing the modified data back to the GETC.
NOTE