Installation manual

OPERATIONAL CHECKOUT LBI-38987B
25
7. Unkey the radio and verify that the station returns to the
Control Channel mode.
Multisite Initiated Calls
1. Initiate a multisite call or a console call to a radio
assigned to the SCAT station.
2. When the call is received, verify that SCAT Station
GETC LED L7 turns OFF and L2 turns ON as shown in
Table 9.
Table 9 - LED Indications, Clear Voice Multisite Call
LED Indicators L1 L2 L3 L4 L5 L6 L7
CV Working Channel
(Multisite initiated call.)
●●❍❍❍●❍
Legend:
❍
= OFF
●
= ON
❉
= FLASHING
3. When the call is finished, verify that the LEDs change
state indicating the station has returned to the Control
Channel mode.
DIGITAL VOICE CHECKOUT
The following tests allow you to confirm the SCAT
Station GETC operation when making Digital Voice (DV)
calls
Locally Initiated Calls
1. Setup the radios for Digital Voice operation.
NOTE
The SCAT Station GETC must have the Wide Area
Digital option enabled to perform this test. Contact
your EGE Sales Representative and ask for option
SXSF7A. If your SCAT Station GETC does not
have a Rockwell Modem, also order option
SXMD1D.
2. Initiate a call from radio 1 to radio 2 using the Digital
Voice mode.
3. When the call is received, verify that SCAT Station
GETC LEDs L1, L6, and L7 turn ON (see Table 10).
Table 10 - LED Indications, Digital Voice Local Call
LED Indicators L1 L2 L3 L4 L5 L6 L7
DV Working Channel
(Locally initiated call.)
●❍❍❍❍●●
Legend:
❍
= OFF
●
= ON
❉
= FLASHING
4. When the call is finished, verify that the LEDs change
state indicating the station has returned to the Control
Channel mode.
Multisite Initiated Calls
1. Initiate a multisite or console DV call to a radio
assigned to the SCAT station.
2. When the call is received, verify that SCAT Station
GETC LED's L1, L2, L6, and L7 turn ON as shown in
Table 11.
Table 11 - LED Indications, Digital Voice Multisite Call
LED Indicators L1 L2 L3 L4 L5 L6 L7
DV Working Channel
(Multisite initiated call.)
●●❍❍❍●●
Legend:
❍
= OFF
●
= ON
❉
= FLASHING
3. When the call is finished, verify that the LEDs change
state indicating the station has returned to the Control
Channel mode.
NOTE