Installation guide

iPECS eMG80

System DECT Installation Guide Issue 1.0

3.6.2 Authentication Code

The Authentication Code is entered at the Attendant station before subscribing a User wireless

terminal to the iPECS eMG80.

To display the Authentication Code, perform the following Steps:

1. From the Attendant station, press [TRANS/PGM]; the [TRANS/PGM] LED will flash (60

IPM) and [ON/OFF] LED will be turned ON.

2. Press 0#.

3. Press the FLEX3 button; the current AC code will display on the LCD.

4. If Authentication code is correct, exit the program mode.

If Authentication code is wrong, please follow the procedure:

1. From the Attendant station, press [TRANS/PGM]; the [TRANS/PGM] LED will flash (60

IPM) and [ON/OFF] LED will be turned ON.

2. Press 0#.

Press the FLEX3 button; the current AC code will display on the LCD.

3. Enter the Authentication Code (up to 8 digits, refer to key sequence description below).

4. When finished, press [HOLD/SAVE]; a confirmation tone will be heard.

The key sequence of the AC code= D______D

 D_______D – Up to 8 digits decimal representation.

Condition

1. AC code must be programmed for User Subscription.

2. AC code must be programmed after the system was installed; if AC code is changed

while under system operation, it may not operate properly (ex., subscribed terminal may

not receive incoming calls or not make an outgoing call).

3. If PARK value is changed, AC code must also be entered again.

4. The initial AC code is 000000.

5. AC code change will not affect the system operation except subscribing new wireless

terminals.