User guide

LIP-8002/8002A iPECS IP Phone
User Guide
5.5. Time Configuration
Within the Time Configuration menu, the IP Address or name of the desired Simple Network Time
Protocol (SNTP) server and the local time zone are defined. And, Daylight Savings Time (DST) is
disabled. Consult with your administrator before changing the SNTP server.
5.5.1. SNTP Server Address
SNTP (Simple Network Time Protocol) is a standard protocol that permits a network device to obtain the
network’s current time. For operation with SNTP, the LIP-8002/8002A IP Phone requires an SNTP server
IP address or name.
To assign the SNTP server address:
o Press the Setting (
) button.
o Dial 3, or move the cursor to 3.Phone Settings using the Up/Down navigation buttons and press the
OK button.
o Dial 5, or move the cursor to 5.Time Configuration using the Up/Down navigation buttons and press
the OK button.
o Dial 1, or move the cursor to 1.SNTP Server Address using the Up/Down navigation buttons and
press the OK button.
o Input the SNTP server address using the dial pad and press the OK button to save the entry. To enter
alphanumeric characters select the Mode button. Refer to Appendix A
for the character mapping of
dial pad digits.
o Move to another parameter with the navigation buttons and continue the session or press the Setting
(
) button to exit the configuration session.
5.5.2. Time Zone
For proper operation of the clock, the IP Phone requires the local time zone.
To enter the Time Zone:
o Press the Setting (
) button.
o Dial 3, or move the cursor to 3.Phone Settings using the Up/Down navigation buttons and press the
OK button.
o Dial 5, or move the cursor to 5.Time Configuration using the Up/Down navigation buttons and press
the OK button.
o Dial 2, or move the cursor to 2.Time Zone using the Up/Down navigation buttons and press the OK
button.
o An asterisk, , displays in front of the current selection. Select the nearest region from the display
using the Up/Down navigation buttons and press the OK button to save the entry.
o Move to another parameter with the navigation buttons and continue the session or press the Setting
(
) button to exit the configuration session.
13