User guide

LIP-8002E/2AE User Guide

1.5.1 Wiring Connectors

The LIP-8002E/2AE has a two Ethernet ports one is

connected to the LAN using a RJ-45 plug terminated

category 5 cable supplied with the Phone, the other can

be connected to a desktop PC. Using the cable, one

RJ-45 plug is inserted into the "LAN" jack. The other RJ-

45 plug is inserted into the RJ-45 jack previously wired

to an Ethernet switch port accessible by the iPECS

system. To power the LIP Phone over the LAN, the

switch port must support POE (Power over Ethernet)

standard 802.3af.

1.5.2 Power

The LIP-8002E/2AE can be powered by the AC/DC

Adapter-K- (5 V @0.7A) or over the LAN cable using the

POE8 or other 802.3af compliant switch. (The LIP-

8002AE isn’t support PoE and can use only the supplied

adaptor)

If using the AC/DC Adapter, after connecting the Phone

to the LAN, the Adapter’s DC voltage plug is inserted

into the power-input jack in the underside of the Phone.

One end of the AC power cord is inserted into the

mating receptacle of the AC Adapter, and the other end

is inserted into the AC power outlet.

1.5.3 Wall Mount

The LIP-8002E/2AE can be wall mounted as needed.

The following instructions detail how to perform a wall

mount installation:

• Mark and drill two (2) 7mm holes for plastic wall anchors.

• Insert the two (2) anchors into the holes and insert and tighten

each screw leaving about 2.5 mm (1/8-inch) of the screw

exposed.

• Slide the LIP-8002E/2AE over the screws and assure the

phone is secure.

• NOTE—It may be necessary to remove the phone and tighten

or loosen the screws for a secure mounting.

• For the wall-mounting, sleeve of the CAT5 cable should be

moved backward to prevent it protrude.