Installation Guide

C5621 and C33 User Guide
1/1553-KRD 131 24 Uen Rev D 2011-11-22

Ericsson AB 2011
30 (37)
Ericsson Confidential
8.1.5 Disposal of old electrical & electronic equipment
All electrical and electronic equipment included should not be treated as
household waste. It should instead be left at the appropriate collection point
for the recycling of electrical and electronic equipment. By ensuring this
product is disposed of correctly, you will help prevent potential negative
consequences for the environment and human health, which could otherwise
be caused by inappropriate waste handling of this product. The recycling of
materials will help to conserve natural resources. For more detailed
information about the recycling of this product, please contact your local city
office, your household waste disposal service or the store where you
purchased your Mobile Broadband Module.
8.1.6 Emergency calls
This Mobile Broadband Modules do not support voice calls or voice services,
nor emergency calls and should not be relied upon for essential
communications.
8.2 Regulatory Information
The Mobile Broadband Module must be installed and used in strict accordance
with the manufacturer's instructions as described in the user documentation
that comes with the product. The device manufacturer is not responsible for
any radio or television interference caused by unauthorized modification of the
devices included with the Mobile Broadband, or the substitution or attachment
of connecting cables and equipment other than that specified by the device
manufacturer. The correction of interference caused by such unauthorized
modification, substitution or attachment is the responsibility of the user. The
device manufacturer and its authorized resellers or distributors are not liable
for any damage or violation of government regulations that may arise from the
user failing to comply with these guidelines.
8.2.1 United States, FCC Notices
Instructions
The integrator must follow the installation instructions in this document and is
required to use an antenna with gain figures within the limits listed on the FCC
Grant and/or the IC Certificate for their products.
If using a permanently affixed label, the modular transmitter must be labeled
with its own FCC identification number, and, if the FCC identification number
is not visible when the module is installed inside another device, then the
outside of the device into which the module is installed must also display a
label referring to the enclosed module. This exterior label can use wording
such as the following: “Contains Transmitter Module FCC ID: VV7-