User's Manual

Technical Description and User Guide F3307
2/1424-LZT 108 9714/01 Uen Rev D 2010-09-03
Ericsson AB 2010
Ericsson Confidential
12 (38)
All components except the antenna connectors are covered by EMC shields. All
power and baseband communication is routed through the edge connector of the
card. The fastening holes in the upper corners are connected to ground.
4.2 Dimensions
The card follows the PCIe specification for type F2 cards. The type F2 is designed to
fit into a full-size Mini card slot or into two half-size Mini card slots. For
measurements, tolerances and other details, please refer to the PCI Express Mini
Card Electro Mechanical specification.
There are up to three connectors located on the card: one system connector located
on one of the short edges, and one or two RF connectors, depending on variant,
located near the corners opposite the system connector, see the figure above.
The RF connectors are of type U.FL. The Main connector is used for UMTS/GSM
transmission and reception. The AUX connector, when available, is used for UMTS
diversity.
The System connector is a straight single 52-pin connector, 26 pins on each side of
the card. The connector is specified in the PCI Express Mini Card specification.