Installation manual

Figure 11 - Remote Mount Extended Option Accessory
Interconnections (USA Models Only)
Figure 12 - Remote Mount Extended Option Accessory
Interconnections (EURO Models Only)
Power Cable
The USA power cable (19B802622P1) consists of a red lead A+ and a
black lead A- connected to a molded 2-pin power connector and
terminated with ring terminals. The EURO power cable also consists of
a red lead A+, a black lead A- and is terminated with ring terminals, but
it is connected to P1 of the Accessory Cable or P1 of the Control Cable
(in remote applications). To install the power cable:
1. Drill a 5/8-inch hole in the firewall for the cable run and insert the
rubber grommet. Run the cable through this grommet to the battery
location. Secure the cable at several locations within the engine
compartment to prevent possible damage to cable.
2. Connect the black lead directly to the battery negative (-) or ground
frame member.
12
Figure 23 - EURO Extended Options Remote Control Cable
19B802554P14
25