LBI-39135 Programming Manual MRK/ORION Diagnostic Radio Code (SPK654) Group 16 or later Ericsson Inc. Private Radio Systems Mountain View Road Lynchburg, Virginia 24502 1-800-528-7711 (Outside USA, 804-528-7711) ericssonz Printed in U.S.A.
LBI-39135 LBI-39135 NOTES NOTICE! This manual covers Ericsson and General Electric products manufactured and sold by Ericsson Inc. NOTICE! The software contained in this device is copyrighted by Ericsson Inc. Unpublished rights are reserved under the copyright laws of the United States. This manual is published by Ericsson Inc., without any warranty.
LBI-39135 LBI-39135 NOTES TABLE OF CONTENTS Page INTRODUCTION ......................................................................... 4 INSTALLATION PROCEDURE ................................................. 4 STEP 1 - INITIAL SET-UP CONDITIONS:............................. 4 STEP 2 - SAVE CURRENT PERSONALITY AND FLASH CODE ...................................................................................... 5 STEP 3 - CREATE TEST PERSONALITY..............................
LBI-39135 LBI-39135 INTRODUCTION The MRK/Orion Diagnostic Radio Code (SPK654) is specially designed radio code that provides diagnostic capability. The Diagnostic radio code is used as temporary replacement radio code for diagnostic purposes only. The Diagnostic radio code installation procedure (using the EDACS-3/CONV-1 PC Programmer) is the same as standard radio code.
LBI-39135 LBI-39135 3. UDC Devices And Programming Resistor The M-RK radio must be interfaced with a variety of accessories with a minimum number of connections. The M-RK software senses the type of accessory connected to the radio by measuring the resistance value connected to pin 8 (UDC SENS IN). The function of the remaining pins are then defined by the software.
LBI-39135 LBI-39135 For an M-RK II with Version 2 Hardware, use file: M2 T 16 2 99.
LBI-39135 LBI-39135 Editable Tx/Rx Diagnostic Variables The radio operates according to the values of the diagnostic variables while in the Diagnostic menu. After exiting the menu (by pressing CLEAR) the radio operation is no longer affected by the values of the diagnostic variables. To modify or change the value of an editable diagnostic variable, press the MENU key when the desired variable is being displayed. This puts the radio in the Entry Mode.
LBI-39135 LBI-39135 USING THE DIAGNOSTIC RADIO CODE POWER-UP TEST MODE Access the Menu by pressing the MENU key on the radio keypad while on a Conventional System. The Power-Up Test Mode is used to verify proper operation of the display/LEDs, keypad, knobs and buttons. The Power-Up Test Mode does not apply to Orion radios due to the built in test provided with the Orion Control Unit Software.
LBI-39135 LBI-39135 tone and the last knob position will cause the radio to sound a high frequency tone. Enabled General Features ⇒ Diagnostic Variables Menu 4. ⇒ Battery Feature ⇒ System Change ⇒ Volume Adjust ⇒ Group/Channel Change Volume Knob Verification. Repositioning of the Volume knob should cause the radio to sound the key-ack tone at the new volume level. M-RK II/M-RK II Scan Disabled General Features 1.
LBI-39135 3. 4. 5. LBI-39135 System/Group Knob Verification. Repositioning the system/ group knob should cause the radio to sound the key-ack tone at the current volume level and display the knob position on the bottom level of the display. The bottom line of the display returns to the full pixel display after approximately one (1) second. Volume Knob Verification. Changing the Volume knob should cause the volume level to change and be displayed on the top line.
LBI-39135 3. 4. 5. LBI-39135 System/Group Knob Verification. Repositioning the system/ group knob should cause the radio to sound the key-ack tone at the current volume level and display the knob position on the bottom level of the display. The bottom line of the display returns to the full pixel display after approximately one (1) second. Volume Knob Verification. Changing the Volume knob should cause the volume level to change and be displayed on the top line.
LBI-39135 LBI-39135 tone and the last knob position will cause the radio to sound a high frequency tone. Enabled General Features ⇒ Diagnostic Variables Menu 4. ⇒ Battery Feature ⇒ System Change ⇒ Volume Adjust ⇒ Group/Channel Change Volume Knob Verification. Repositioning of the Volume knob should cause the radio to sound the key-ack tone at the new volume level. M-RK II/M-RK II Scan Disabled General Features 1.
LBI-39135 LBI-39135 USING THE DIAGNOSTIC RADIO CODE POWER-UP TEST MODE Access the Menu by pressing the MENU key on the radio keypad while on a Conventional System. The Power-Up Test Mode is used to verify proper operation of the display/LEDs, keypad, knobs and buttons. The Power-Up Test Mode does not apply to Orion radios due to the built in test provided with the Orion Control Unit Software.
LBI-39135 LBI-39135 Editable Tx/Rx Diagnostic Variables The radio operates according to the values of the diagnostic variables while in the Diagnostic menu. After exiting the menu (by pressing CLEAR) the radio operation is no longer affected by the values of the diagnostic variables. To modify or change the value of an editable diagnostic variable, press the MENU key when the desired variable is being displayed. This puts the radio in the Entry Mode.
LBI-39135 LBI-39135 For an M-RK II with Version 2 Hardware, use file: M2 T 16 2 99.
LBI-39135 LBI-39135 3. UDC Devices And Programming Resistor The M-RK radio must be interfaced with a variety of accessories with a minimum number of connections. The M-RK software senses the type of accessory connected to the radio by measuring the resistance value connected to pin 8 (UDC SENS IN). The function of the remaining pins are then defined by the software.
LBI-39135 LBI-39135 INTRODUCTION The MRK/Orion Diagnostic Radio Code (SPK654) is specially designed radio code that provides diagnostic capability. The Diagnostic radio code is used as temporary replacement radio code for diagnostic purposes only. The Diagnostic radio code installation procedure (using the EDACS-3/CONV-1 PC Programmer) is the same as standard radio code.
LBI-39135 LBI-39135 NOTES TABLE OF CONTENTS Page INTRODUCTION ......................................................................... 4 INSTALLATION PROCEDURE ................................................. 4 STEP 1 - INITIAL SET-UP CONDITIONS:............................. 4 STEP 2 - SAVE CURRENT PERSONALITY AND FLASH CODE ...................................................................................... 5 STEP 3 - CREATE TEST PERSONALITY..............................
LBI-39135 LBI-39135 NOTES NOTICE! This manual covers Ericsson and General Electric products manufactured and sold by Ericsson Inc. NOTICE! The software contained in this device is copyrighted by Ericsson Inc. Unpublished rights are reserved under the copyright laws of the United States. This manual is published by Ericsson Inc., without any warranty.
LBI-39135 Programming Manual MRK/ORION Diagnostic Radio Code (SPK654) Group 16 or later Ericsson Inc. Private Radio Systems Mountain View Road Lynchburg, Virginia 24502 1-800-528-7711 (Outside USA, 804-528-7711) ericssonz Printed in U.S.A.
