User manual

3. Press the CHANNEL/SEL (+) button until the desired priority level

is displayed by the scan priority indicators on the right side of the

display; the choices are S, P2; P1 or all off (all off removes the channel

from the SCAN list).

4. Press the CLR button when completed to return to normal operation.

If your radio has one of the auxiliary keys preprogrammed to edit the SCAN

list, the list may be changed by using the CHANNEL/SEL buttons to display

the CHANNEL name, and then pressing the auxiliary key until the desired

level is displayed.

The SCAN function allows monitoring of up to 1 6 receive channels on the

selected system. The scanned channels may be any frequency within the

frequency band limits of the radio and may be Channel Guard protected. All

scan functions are retained in memory, even if the 12 Volt vehicle battery is

disconnected.

Any channel may be scanned with or without a priority level. One channel

may be programmed for Priority 1 (P1) and another for Priority 2 (P2) with

any or all remaining channels programmed as non-priorities.

RECEIVER SCAN RATE

The scan rate for the radio will vary depending upon the number of channels

programmed into the scan list and whether or not Channel Guard is

programmed. The scan rate will be faster when fewer channels are program-

med into scan memory.

1. The radio will remember the scan state through a power cycle

unless programmed with a predefined power up state.

2. The radio may be programmed to stop scanning when the

microphone is removed from the hookswitch.

3. When the radio is programmed, a FIXED SCAN list can be

specified. If this is done, the SCAN list cannot be changed.

4. A previous channel with priority will become a non-priority scan

channel when a new priority channel is programmed.

NOTES