User manual

Monitor (CLR) Switch Operation In Scan
The CLR switch does not operate while scanning inactive channels. When
a channel becomes active, the CLR switch operates only during the scan hang
time after the channel activity disappears.
Channel Changes In Scan
Pushing the channel switches (UP or DOWN) while scan is turned on will
change the SELECTED channel assignment. If a signal is being received and
the channel switches are pushed, the radio will revert to the new SELECTED
channel assignment. After 2 seconds, if no activity appears on the new
SELECTED channel, scanning will resume. if the SELECTED channel is
changed to a channel not in the scan list, the new channel will be temporarily
added to the scan list until the SELECTED channel is changed again.
• Temporary channel deletions
The SCAN function must be turned off to make any permanent changes
(additions, deletions, re-priorizations) to the scan list. While in scan,
temporary channel deletions may be made to the scan list. The original
scan list will be back in effect by either turning scan off (by pushing the
SCAN switch ) or by turning the radio power off and back on.
When the radio stops scanning on an active channel, the channel may
be temporarily deleted by pressing the applicable A1 or A2 key
(pre-programmed for SCAN ADD/DELETE) or by going into Menu
mode SCAN ADD/DELETE and pressing the CHANNEL/SELECT
UP(+) button. The radio will immediately resume scanning while
skipping over the temporarily deleted channel.
Temporary deletions cannot be made until the radio stops on an active
channel. P1 and P2 channels cannot be temporarily deleted.
18