Installation Guide

Remove Old Toilet

Installation

Installation Guide

a) To replace the original toilet, shut off the water supply valve and flush tank

completely. Disconnect and remove the supply line.

b) Clear the sealant around the toilet base, unscrew the bolts, and remove the toilet.

c) Remove closet bolts from the toilet flange and clean wax and putty using putty

knife. Clean the floor.

a) Measure the distance from the wall to the

centerline of the flange. While most bathrooms

have a 12-inch (305mm) rough-in, 10-inch and

14-inch are two common rough-in sizes, too.

Make sure the purchased model matches the

rough-in measurement in your bathroom.

b) Make sure the area for toilet is clean, dry,

and level.

c) Inspect existing closet flange. Replace if

necessary.

d) Temporarily plug the flange with a towel or

flange plug.

Confirm Rough-in & Levelness

Apply Wax Gasket and Sealant

Closet Flange

Closet Bolts

Rough-in

a) Invert the toilet on the floor.

into position to prevent the toilet from shifting over time and damaging the wax

seal.

REMINDER When replacing the flange, always remember to lock the nuts