Installation Guide
04
Installation Guide
Position Toilet onto Flange
a) Unplug the floor opening and position the toilet on the flange so the closet bolts
project through the pre-drilled holes around the rear of the toilet trapway.
b) Position the toilet squarely to the wall, and press down fully on the wax ring and
flange to create a watertight seal. Alternately tighten nuts until the toilet is firmly
seated on the floor.
c) Smooth off a bead of sealant around the base. Remove any excess sealant.
d) Install the washers and nuts onto the bolts. Do not over-tighten as it might crack
the ceramics.
b) Apply the wax ring gasket evenly
around the rear of the trapway.
c) Apply a thin bead of sealant
around the toilet base.
REMINDER Consider placing
a tarp over the floor for surface
protection.