Instruction manual

On
When the ignition switch is turned to
the ACC or ON position, press
button on the panel to turn the unit on.
Off
After the unit is started, hold
button for 3 seconds or more to turn
the unit off.
Turn the unit on/off
Enter into the Main Interface
When the unit is turned on, press
button on the panel to switch to the
main interface.
If a function icon listed above
appears grey, it indicates there is no device
get connected to the unit under the current
status, operation is ineffective.
Touch each function icon to enter into
the corresponding function operation.
Touch icon in the main interface
to enter into the radio interface.
Radio Function Operation
After touching icon and entering
into the radio main interface, touch
other function icons to exit the radio
mode.
Enter/exit
Basic Operation Function Operation
Auto search and store station
(1) Touch [AUTO] icon in the radio
interface or press [AMS] button on the
panel to search for station automatically.
During search, the searched stations will
be stored automatically.
(2) During search, retouch [AUTO] icon
or [ AMS] button to stop auto searching.
(3)After stations are searched and stored,
the unit will start browsing each station
for 5 seconds. During browse, when you
find your favorite program and need to
stop browsing, touch any button on the
screen to stop.
Manual search and store station
(1)Touch [Search+/-] button in the radio
interface to search for station manually.
Touch [Search-] button to search for a
station upward; Touch [Search+] button
to search for a station downward.
During search, after a station is searched,
the unit will stop searching automatically
and play the searched station radio.
(2) Directly touch icon in the radio
interface to fine-tune station frequency.
(3) After a station is searched, (such as:
98.00MHZ), long press any position in
the pre-stored station list in the radio
main interface, the searched station will
be stored in the selected position
(such as: ).
Search/store/browse station
Enter/exit
Touch in the main interface to
enter navigation.
Touch [Exit System] icon in the
navigation main interface to exit
navigation system.
Navigation PPT
You can enable DVD/video/radio
function simultaneously during
navigation by navigation push-to-talk
function.
For example:
Press [NAVI] button in navigation
interface to switch to the main interface,
select DVD icon, system will read the
disc and switch to DVD playback
screen while the navigation tone output
continues. Then, press [NAVI] button on
the system operation panel, system
switches to navigation screen, at this
time, DVD playback continues but only
sound output. If you wish to exit DVD
mode, press [NAVI] button to switch to
the main interface, then press icon
to exit DVD mode.
Navigation function operation
The unit supports enquiry function
of destination by touch input and
handwriting input. For detailed
operation of navigation function, see
“Navigation Operation Manual”.
Receiving signal error
When the satellite signals can be
normally received, the error of standard
GPS shall be about 7 meters. Driving
on parallel sections, there shall be
error even the product has auto-correct
function. The normal receiving of
satellite signals shall be affected and
cause error in following environment:
GPS Navigation Function Operation
Receiving of satellite signals
Navigation system can keep receiving
8 satellite signals. As a general rule, the
navigation system can figure out your
accurate location after received 3-4
satellite signals. But some times,
weather and tall buildings in the city
shall affect the signal receiving effect,
as is shown n following figure:
In tune
Among tall buildings
At the boulevard
The antenna is sheltered
Underground parking
Overpass or viaduct
Scope for receiving satellite signals
Angle of
elevation
Angle of
elevation
Function Operation