Instruction manual

Function Operation
Select station/band switch/switch
between LOC/DX
RDS function
(1) Directly touch any station in the
pre-stored station list in radio interface
to play the selected station.
(2) Touch ﹝Band﹞button in radio
interface to switch band among FM1,
FM2, FM3, AM1 and AM2.
(3) Touch ﹝LOC﹞icon to switch search
mode between LOC and DX. When LOC
function is turned on, only those radio
stations with strong signals and good
reception can be received; When DX
function is turned on, distant weak radio
signals can be received.
P1---program identification
TA---traffic announcement
PS---program service name
PTY---program type name
AF---alternative frequencies
EON---enhanced other network
TP---traffic program
RDS provides a series of information
(such as traffic information and station
name), and can automatically switch to
a station with strong signals and carries
the same program.
RDS data contains the following contents:
1. AF
Touch the button to turn the AF
function on/off.
When the received station
signals become weak, the radio will
automatically fine-tune to other
frequencies.
When receiving an emergency
announcing, the screen will display
warning message “ALARM“.
Receive traffic information
①Press [TA] button to open TA mode.
② When the traffic station is turned on,
the radio will automatically search
for traffic stations. After a station is
searched, screen displays “TP”.
Only when traffic information is
broadcasted can it be received, after
traffic information is completed, the
radio will automatically switch to the
previous mode.
③ Repress [TA] button to close
TA function. In other modes, traffic
announcement will automatically
switch to radio mode, after the traffic
announcement is completed, it will
automatically switch to the previous
mode.
2. PTY
PTY function allows searching for
special program types.
① Touch PTY button to select searched
program type.
② Three seconds after the program
type is selected, the radio will
automatically search for station to the
selected program type.
3. EON
ON: Open EON function, another AF
list is received.
OFF: Close EON function.
4. REG
ON: Open REG function, only local
RDS stations can be received.
OFF: Close REG function.
Enter/exit
Touch icon in the main interface to
enter the TV playback interface.
Touch icon to exit TV mode.
Search & save channel
Auto search & save channel
You may need to search for station first
before you use TV.
Touch [Auto] button in the interface to automatically start searching for TV
channels within the scope of all the TV channels, effective TV channels searched
will be automatically memorized in the preset channels in ascending order.
During search, retouch [Auto] button to stop searching.
Manual search channel
Long touch [Search +] and [Search -] button on display screen to search for station in
a single step.
Hold [Search +/-] button on display screen for 2 seconds or more to automatically
search for effective stations in the frequency ascending/descending direction.
Select channel and play
Touch [Search +] and [Search -] button on display screen to select the next/previous
aved channel to play.
Sound system switch
Touch the position of sound system switch on display screen to switch TV sound
system in the following order:
If abnormal sound appears, that may be because the sound system setup is wrong,
you need to reset it.
(Sound system adopted in China: Mainland areas except Shenzhen etc.: 1; other areas:
DK; Hong Kong: 1 Users should pay special attention to this.)
Analog TV Function Operation
PAL 1→ NTSC→ SECAM→ DK→SECAM-BG→ PAL-DK→ PAL-M→ PAL-N→ PAL-BG
Function Operation