User manual

The PHONE key is used in connexion with the VST 10CA Fast Scan to display the list
of phone numbers, select a phone number and dial up.
The AUDIO key is used in connexion with the VST 10CA Fast Scan to enable audio
transmission from the transmitter site to the receiver site. Pressing the AUDIO key a
second time will disable the audio transmission again.
Pressing the ESC key immediately followed by the AUDIO key will enable audio
transmission in the opposite direction, i.e. from the receiver site to the transmitter
site. Pressing this key combination a second time will disable the audio transmission.
The audio quality can be selected by pressing the numerical keys 1, 2, or 3 in front
of the AUDIO key.
The QUAD key is used in connexion with the VST 10CA Fast Scan to set the video
display in quad mode. Pressing the key a second time will toggle the display mode
back to full screen.
The ENHANCE key is used in connexion with the VST 10CA Fast Scan to toggle
between two predefined display resolutions. It is also possible to directly specify the
picture resolution by pressing a numerical key in the range of 1 to 8 in front of the
ENHANCE key.
ON OFF
The CONTROL ON/OFF keys is used in connexion with the VST 10CA Fast Scan to
control the corresponding control outputs 1-10 on the Fast Scan located at the
transmitter site. If the control output 3 should be activated, press the numerical key
"3", and immediately after the key "CONTROL ON".
The ten control outputs are intended for user selected functions such as lights,
washer, wiper and gates.
MODE
1/2
The MODE 1/2 key is used in connexion with the VM-12 Video motion detection
modules fitted in the VMD-10 rack frame to select the mode of operation between
two pre-programmed setup's. If operating mode 2 should be selected on the VM-12
module currently being controlled, press the numerical key "2", and immediately
after the key "MODE 1/2".
The DETECTION ON and DETECTION OFF keys are used in connection with the
VM-12 Video motion detection modules fitted in the VMD-10 rack frame to select
the DETECTION mode.
For further information refer to the Adpro VMD-10 Manual.
DET
ON
DET
OFF
The DETECTION ON and DETECTION OFF keys are used in connection with the
VM-12 Video motion detection modules fitted in the VMD-10 rack frame to select
the DETECTION mode.
For further information refer to the Adpro VMD-10 Manual.
Second key
functions F1 - F12
These keys are used only during setup of the keyboard; refer to the keyboard
manual or the SYSTEM 500M Programming Manual.
User Manual for SYSTEM 500M
Number 2822-00025 GB - Page 7