Installation Guide

12
6. Standard Installation (with ECM Connection)
NOTES
• If you are operating a pre-2000 vehicle or post-2000 vehicle
with no ECM connection (e.g. mechanical engine), refer to
Installing the Ehubo – No Electronic Control Module (ECM)
connection.
• The engine must be turned o prior to installing Ehubo.
• Power supply must not be taken from any Anti-lock Braking
System (ABS) / Electronic Braking System (EBS).
6.1 HARDWARE
1
Connect the 8-way connector (M) on the extendable cable (N)
to the corresponding connector on the ECM Y-cable (O). Secure
with the cable clamp (J) included in your cable kit.
2
Remove the vehicle’s diagnostic connector (data connector)
from the bracket or panel where it is fastened. Consult your
vehicle’s maintenance guide to properly remove panels, as
required.
3
Connect the vehicle’s diagnostic connector to the mating
connector on the ECM Y-cable (L2) and secure by twisting the
collar until it locks into place (tug lightly to check). Your Ehubo
display screen should power on at this point with a green LED
(P) above the display.
4
Feed the second connector on the ECM Y-cable (L1) into the
existing vehicle diagnostic connector housing and fasten to
the vehicle.
5
Finalize by following the on-screen instructions. (See section
6.2) After the checks are successfully completed, the Pending
Assignment, or the Ehubo home screen (if unit is assigned to a
vehicle) is displayed.
6
Store all unused wires neatly, insulated and secured using cable
ties. Reinstall any dashboard pieces or panels removed during
installation. Remove the screen protection film from the Ehubo
display screen. Ensure the driver-required manual and visor
cards are in the vehicle.
NOTES
If additional wires are required for monitoring activity through the
three digital inputs, connect to their respective sources with an in-
line 3A fuse listed in section 4.3.
Electronic logs are activated in Depot after installation. Contact
your Customer Success Account Manager for more information,
if needed.
2