Installation Guide

22
7.2 RUNNING THE INSTALL WIZARD (NON-ECM INSTALLATION)
You must run the Install Wizard to complete your installation on
vehicles with a non-ECM connection. Typically, these vehicles
were manufactured in the year 1999 or earlier. This device is hard-
wired for ground, permanent power, and ignition.
Perform the following steps to run the Install Wizard.
1. The Welcome screen appears once the Ehubo is physically
installed and the vehicle is powered ON.
Tap the Start button.
The Install Wizard displays a message that it is checking for
updates. Please wait until this cycle is completed and the Up to
Date screen appears.
2. Tap the Continue button in the Up to Date screen.