Installation Guide
32
14. Tap the Engine O button.
15. The Ehubo is now testing the external power source to ensure
that the device is receiving the proper voltage from the diagnostic
connector. Tap the OK button to continue.
Note: The device might restart if the power supply is not adequate.
Next, the green check marks on the Installation Complete screen
indicate that the unit has good external power, the wiring checks
are complete, and the system is now ELD ready. ELD ready
means that this vehicle is now ready to be enabled in Depot to
collect electronic logs on the device.
16. Tap the Finished button.
You've successfully completed the installation wizard. The
following Pending Assignment screen appears until you assign
the Ehubo to a vehicle in the Depot application.
NOTE: Enabling the device is typically performed in the Depot
application by your back oce personnel. See the Assign an
Ehubo to a Vehicle training lesson for more information.