Certifications 2

Page 3/5
Safety data sheet
according to 1907/2006/EC, Article 31 and 453/2010/EC
Printing date 30.01.2017 Revision: 30.05.2016Version number 2
Trade name: FELDER Tinner "bleifrei"
FELDER Tinner lead-free
Sn97Cu3
(Contd. of page 2)
44.1.3
Protection of hands:
Selection of the glove material on consideration of the penetration times, rates of diffusion and the degradation
Material of gloves
Nitrile rubber, NBR
The selection of the suitable gloves does not only depend on the material, but also on further marks of quality and
varies from manufacturer to manufacturer. As the product is a preparation of several substances, the resistance of the
glove material cannot be calculated in advance and has therefore to be checked prior to the application.
Recommended thickness of the material:
≥
0,4 mm
Penetration time of glove material
The exact break through time has to be found out by the manufacturer of the protective gloves and has to be observed.
The determined penetration times according to EN 374 part III are not performed under practical conditions. Therefore
a maximum wearing time, which corresponds to 50% of the penetration time, is recommended.
Value for the permeation: Level
≤
6
Eye protection:
Not required.
Body protection:
Protective work clothing
SECTION 9: Physical and chemical properties
9.1 Information on basic physical and chemical properties
General Information
Appearance:
Form:
Solid
Colour:
Grey
Odour:
Characteristic
Odour threshold:
Not determined.
pH-value:
Not applicable.
Change in condition
Melting point/freezing point:
Not determined
Initial boiling point and boiling range:
Undetermined.
Flash point:
Not applicable.
Flammability (solid, gas):
Not determined.
Ignition temperature:
Decomposition temperature:
Not determined.
Auto-ignition temperature:
Product is not selfigniting.
Explosive properties:
Product does not present an explosion hazard.
Explosion limits:
Lower:
Not determined.
Upper:
Not determined.
Vapour pressure:
Not applicable.
Density at 20 °C:
2,17 g/cm³
Relative density
Not determined.
Vapour density
Not applicable.
Evaporation rate
Not applicable.
Solubility in / Miscibility with
water:
Insoluble.
Partition coefficient: n-octanol/water:
Not determined.
Viscosity:
Dynamic:
Not applicable.
Kinematic:
Not applicable.
Solvent content:
Organic solvents:
0,0 %
Water:
1,0 %
VOC (EC)
0,0 %
0,00 %
Solids content:
99,0 %
9.2 Other information
No further relevant information available.
SECTION 10: Stability and reactivity
10.1 Reactivity
No further relevant information available.
(Contd. on page 4)
EU