User manual

-- 1 6 --
bi02d1aa
5.3 Settings example
Setting Value
Process Arc--air gouging
Current 45 V
Process = Arc--air gouging
S Select the p rocess by pressing the first function pushbutton until is shown in
the display.
Current = 45 V
S Turn the knob for setting the current until the display shows 45 V.
6 FAULT CODES
Fault codes are used to indicate that a fault has occurred in the equipment. T hey are
shown in the display in the form of a symbol as follows:
Fault codes are updated every three seconds. The upper numeral in the
symbol is the number of the particular fault code: see Item 6.1. The lower
figure indicates where the fault is:
0 = the control panel
2 = the power unit
3 = the wire feed unit
4 = the remote control unit
The above symbol shows that the control panel (0) has lost contact with the power unit.
If severa l faults have been detected, only the code for the last fault to occur will be
displayed.
Press any of the function keys in order to clear the symbol from the display.
US