User manual

-- 1 2 --
bm20d2e
2 INTRODUCTION
A10--MEK 44C is a four--wheel drive wire feed unit with double motors intended for
MIG/MAG welding where the wire is projected in accordance with Esab’s A10
system.
The unit has space for a wire reel with a diameter of up to 440 mm.
For a wire feed unit to be complete it must be equipped either with a turnable,
counterbalance device or a carriage. A turnable or counterbalance device allow the
wire feed unit to be mounted on a pivot on the power source. A carriage allows the
wire feed unit to be m oved easily over the floor or work table.
A wire feed unit and turnable or carriage can also be fitted with a support device and
suspended over the work place.
All the settings are controlled by the PUA1 setting
box.
2.1 TECHNICAL DATA
Voltage 42 V 50--60 Hz
Power consumption 430 VA
Wire feed speed 1,5--25 m/min
Torch connection EURO
Weight 22 kg
Dimensions lxwxh 493x336x268 mm