User manual

-- 1 5 --
bm20d12e
The brake hub
The hub is adjusted when delivered, if
readjustment is required, follow the instructions
below. Adjust the brake hub so that wire is slightly
slack when wire feed stops.
S Adjusting the braking torque:
S Turn the r ed handle to the locked position.
S Insert a screwdriver into the springs in the hub.
Turn the springs clockwise to reduce the braking torque
Turn the springs anticlockwise to increase the braking torque. NB: Turn both
springs through the same amount.
8 ORDERING SPARE PARTS
MEK 44C is designed and tested in accordance with the international an European
standards IEC/EN 60974--1 and EN 50199.
It is the obligation of the service unit which has carried out the service or repair work
to make sure that the product still conforms to the said standard.
Spare parts are ordered through your nearest ESAB representative, see back cover.
When ordering spare parts, please state machine type and number as well as desig-
nation and spare part number as shown in the spare parts list.
This will simplify dispatch and ensure you get the right part.
9 ACCESSOIRES
See Spare part list.
Turntable
At the base of the turntable is a tube which can be fitted over a vertical pivot. The
turntable is delivered with an insulated pivot which can be fitted in a hole on top of
the power source, allowing the wire feed unit to be swung around as far as the gas
bottle.
Suspension device
The suspension device is intended to allow the wire feed unit to be hung
above the work place.
WARNING -- TIPPING RISK!
Fasten the equipment -- particularly if the ground is uneven or sloping.
GB