User Manual

User Manual 06
Installation
TRANSPORT
Move cautiously. Do not grasp any salient parts of machine.
The machine door can not be used as the handle for delivery.
If the dryer can’t be transported erect, the dryer could be
slant to right less than 30°.
INSTALLATION POSITION
1. It is recommended that, for your convenience, the
machine is positioned close to your washing machine.
2. The tumble dryer must be installed in a clean place,
where dirt does not build up. Air must be able to
circulate freely all round the appliance. Do not obstruct
the front air inlet or the air intake grills at the back of the
machine.
3. To keep vibration and noise to a minimum when the
dryer is in use, it should be placed on a rm and level
surface.
4. The feet must never be removed. Do not restrict the
oor clearance through deep pile carpets, strips of
wood or similar. This might cause heat built-up which
would interfere with the operation of the appliance.
LEVEL ADJUSTING
Once in its permanent operating position, check that the
dryer is absolutely level with the aid of a spirit level. If it is
not, adjust the feet with a tool.
NOTE!
Leave it to stand for 2 hours after transporting. Before rst
use, please use the soft fabric to clean the inside drum.
1. Put some clean rags into the drum.
2. Plug the power, press On/O
3. Select the Refresh Program, press Start/Pause button
4. After nishing this program, please follow the “Cleaning
And Care” to clean the lter door.
During drying, the compressor and the water pump
generate some noise which is entirely normal (only for
EHPD7).
ADVICE
1. Before drying, thoroughly spin the laundry in washing
machine. High spin speed can reduce the drying time
and save energy consumption.
2. For uniform drying result, sort the laundry according to
fabric type and drying program.
3. Before drying, please close zips, hooks and eyelets,
button up, tie fabric belts, etc.
4. Do not over dry the clothes, because over dried clothes
can easily get creases or shrinkage.
5. Do not dry the articles containing rubber or similar
elastic materials such as raincoats, bicycle covers and
etc.
6. The door can be opened only after the program of the
drying machine is completed. Do not open the door
before the program nished, as the skin may be scalded
by steam or hot surface.
7. Clean the lint lter and empty container after each
use to avoid extension of drying time and energy
consumption.
8. Please choose the related program when deal with
wool material clothes, to make the cloth more fresh and
uy.
9. The weight references as follows: