User Manual
esatto.house
17
CLEANING THE INLET FILTER
You should clean the inlet lter periodically, or if you nd
that insucient water is being supplied to your washing
machine when the supply tap is open.
To clean the inlet lter:
Close the water supply tap.
Select any wash program (except for Spin Only or Drain
Only) and press the Start/Pause button. Allow the program
to run for about 40 seconds.
Remove the inlet pipe from the closed tap and use water to
wash the lter.
Reconnect the inlet pipe to the tap.
To clean the washing machine lter:
Screw o the inlet pipe from the rear of the
washing machine.
Pull out the lter with long nose pliers, wash it thoroughly
with water and re-install the lter.
Reconnect the inlet pipe to the rear of the washing machine.
Open the water supply at the tap and ensure there is no
water leakage.
Once nished, close the water supply tap.
Note: Generally the tap inlet lter is washed rst followed
by the washing machine lter. If only the washing machine
lter is washed, then you should still follow steps 1-3 for
cleaning the inlet lter rst.
CLEANING THE DRUM PUMP FILTER
REMOVING FOREIGN OBJECTS
WARNING: To avoid the risk of an electric shock, always
remove the power plug from the power
outlet before cleaning the Drain Pump lter.
Periodically you should clean the drain pump lter to ensure
normal operation of your washing machine. The type of
washing, frequency and soil level of your washing cycles
will alter how often this procedure needs to be undertaken,
however you should inspect the lter regularly.
Should your washing machine not empty and/or spin, or
your machine makes unusual noises during
operation, your Drain Pump lter could be blocked. Follow
this procedure to check or remove any foreign objects.
After disconnecting the power, open the lter cover at the
front base of your washing machine.
Unscrew the lter in an anti-clockwise direction and remove
any foreign objects.
Re-install the lter and close the service panel.
WARNING: Never remove the pump cover when the
washing machine is in operation, always wait until the
appliance has nished and the is empty. There can be hot
water within the pump, so be careful to avoid burns, should
it have operated recently. When replacing the cover, be
careful to ensure it is closed securely.