User's Manual

READ THIS MANUAL BEFORE USING THIS PRODUCT.
FAILURE TO FOLLOW THE INSTRUCTIONS AND
SAFETY PRECAUTIONS IN THIS MANUAL CAN
RESULT IN SERIOUS INJURY OR DEATH.
INTRODUCTION
Thank you for choosing the Series 2, we really
appreciate all your support.
This manual should provide you all the information
that you need to operate your Series 2, but if you
experience any issues at all then please don’t hesitate
to contact us through our website or social media
platforms.
SWITCHING ON AND PAIRING THE SERIES 2
(STEREO USE)
1. Remove both Series 2 from the charging case
2. Both Series 2 will now switch on and connect
automatically with each other
3. After a short ‘beep’ the Series 2 will now search
for a Bluetooth device
4. Turn on the Bluetooth on your device
CONNECTING THE SERIES 2 TO YOUR DEVICE
1. Once the Series 2 are paired this will be indicated
by flashing red and blue lights in the left (master)
Series 2 and a flashing blue light in the right
(secondary) Series 2
2. Open the Bluetooth option on your mobile device
3. Select the option ‘S.2’
4. Once the connection has been achieved your
Bluetooth status will display as ‘Connected’ and an
audio message of ‘Connected’ will be transmitted
by the Series 2
Right and left earbuds can be used individually
(mono) or simultaneously (stereo)
Diameter: 17mm
Bluetooth Chip: Realtek
Bluetooth Version: V5
Bluetooth Frequency: 20HZ-20KHZ
Sensitivity: -38db MIC
Earbud Battery: 40 mah with rechargeable
customised Li-ion single cell
Distance: At least 10 meters (without obstacles)
Playing Time: Up to 4.5 hours
Standby Time: 100 hours (mono), 45
hours(binaural)
Built-in CVC 6.0 noise cancellation technology
6mm high fidelity speakers
Charging Case: 500 MAH
Support: Android and IOS system
Bilateral calling
1.
2.
3.
4.
5.
6.
7.
8.
9.
10.
11.
12.
13.
14.
15.
1. Charging Case
2. Charging Indicator
3. Charge Contact Point
4. Ear Tip
5. Ear Brace
6. Microphone
7. Multi-Function Key (Pair, Pause/Play, Answer Call/
Dial, Play Next Song/Previous Song)
PRODUCT FUNCTION PARAMETERS
AUTOMATICALLY RECONNECT THE SERIES 2
1. Ensure that the Bluetooth is activated on the
device that you have previously connected with
the Series 2
2. The device must be within 10 meters of the
Series2
3. Press and hold the multi-function button on both
Series 2 for 6 seconds
4. Both earbuds will automatically connect with each
other (you’ll hear a ‘beep’)
5. The Series 2 will now search for a Bluetooth device
which they have previously been connectedto
6. The Series 2 will now automatically connect to
your Bluetooth device
ESC SOUNDS SERIES 2
User Manual
PRODUCT DESCRIPTION
HOW TO USE
SWITCHING ON AND CONNECTING THE SERIES 2
(SINGLE USE)
1. Remove the left Series 2 from the chargingcase
2. Hold down the multi-function button for 6 seconds
3. After a short ‘beep’ the switched on Series 2 will
now search for a Bluetooth device
4. Turn on the Bluetooth on your device
5. Select the option ‘S.2’
6. Once the connection has been achieved your
Bluetooth status will display as ‘Connected’ and an
audio message of ‘Connected’ will be transmitted
by the Series 2